The VT-VSPA1-1-1X-SO43A-1729 is a state-of-the-art analog amplifier from Bosch, designed for controlling proportional pressure valves. Weighing 0.1 kg, it uses a single solenoid, operates within an ambient temperature range of 0 to 50 degrees Celsius, and features a 32-pole male multipoint connector and front plate. The unit's dimensions are 128.4mm in height, 20mm in width, and 165mm in depth. The amplifier operates at a nominal voltage of 24 Volts DC, with a lower limit of 22 Volts DC and an upper limit of 35 Volts DC. Its maximum power consumption is 50 VA and peak current consumption is 1.8 Amps. Built with a 2.5 Amps slow-blow fuse, the amplifier allows for customizable settings, equipped with DIL switches. Assembly and maintenance should be carried out by trained personnel with the unit de-energized, adhering to the stipulated distance rules from aerial lines, radar systems, radios, and power lines. It also specifies the usage of relays with gold-plated contacts for switching command values, and requires solenoids to be shielded for optimal performance.
Type: Amplifier Designed For: Controlled proportional pressure valves Device Type: Analog Solenoid Count: 1 Connector Type: 32-pole male multipoint Weight: 0.1 kilograms Working Temperature: 0 to 50 degrees Celsius Storage Temperature: -25 to 85 degrees Celsius Nominal Operating Voltage: 24 Volts DC Lower Limit Operating Voltage: 22 Volts DC Upper Limit Operating Voltage: 35 Volts DC Maximum Power Consumption: 50 VA Peak Current Consumption: 1.8 Amps Fuse Type: 2.5 Amps slow-blow Mounting Orientation: Vertical Height: 128.4 millimeters Width: 20 millimeters Depth: 165 millimeters DIL Switches: Customizable Ramp Time (Default Setting): 5 seconds Pilot Current (Default Setting): 100 milliamps Output Current (Default Setting): 800 milliamps Clock Frequency (Default Setting): 200 Hertz Assembly Requirement: Device must be de-energized Relay Requirement: Conductors need gold-plates contacts Solenoid Shielding: Required Required Distance from Aerial Lines, Radar Systems, Radios: At least 1 meter Laying Solenoid Conductors and Signal Lines near Power Lines: Not Recommended Handling Requirement: Trained personnel only