HCS01.1E-W0018-A-03-E-S3-EC-NN-L4-NN-FW
HCS IndraDrive Controllers
Technical Specifications
Communication Interface
SERCOS III
Pairing Note
Paired with Control Section Design 'ECONOMY' (E)
Control Section Design Type
ECONOMY
Cooling Method
Air, internal (through integrated blower)
IP Rating
IP20
Design Version
1
Other Design Features
None
Interface 1 Type
Encoder IndraDyn Hiperface/EnDat 2.1/2.2
Interface 2 Type
Not equipped
Safety Interface
STO (Safe Torque Off) and SBC (Safe Brake Control)
Line Series
HCS01
Mains Voltage
3 x AC 200...500 V ±10%
Device Peak Current
18 A
Power Supply Unit
Infeeding / Feeded
Product Type
HCS Drive Controller
Frequently Asked Questions
What ambient temperature must be maintained for safe operation?
The ambient temperature must not exceed 40 °C under nominal load to avoid thermal stress and internal derating. The controller may require forced cooling or derating above this threshold.
What moisture and condensation constraints apply to installation?
The drive must be installed in areas where condensation cannot occur to protect against insulation breakdown. The enclosure should maintain internal humidity below dew point thresholds.
How does HCS01.1E-W0018-A-03-E-S3-EC-NN-L4-NN-FW handle airborne contamination?
The unit is rated for Pollution Degree 2, restricting use to environments with non-conductive dust only. The cabinet must filter or seal against conductive contaminants and particles.
What grounding requirements suit higher leakage current levels?
The equipment grounding conductor must meet minimum cross-section specifications (≥ 10 mm² copper or equivalent). The grounding ensures safe discharge of leakage currents exceeding 3.5 mA under fault or normal conditions.
How must spacing clearances be managed in chassis mounting?
The controller requires at least 90 mm clearance above and below for proper convection airflow. The spacing avoids heat buildup and ensures thermal stability in dense cabinet layouts.
Common Misspellings
HCS011EW0018A03ES3ECNNL4NNFW
HCS01 1E W0018 A 03 E S3 EC NN L4 NN FW
hcs01.1e-w0018-a-03-a-et-ec-nn-l3-nn-fw
HCS1.1E-W0018-A-03-E-S3-EC-NN-L4-NN-FW
Internal Product Review
The HCS01.1E-W0018-A-03-E-S3-EC-NN-L4-NN-FW by Bosch Rexroth supports EtherCAT connectivity, includes a multi-encoder interface with EnDat and Hiperface compatibility, and features safety level L4 with Safe Torque Off and Safe Brake Control. Its IP20-rated design with internal air cooling suits automated assembly, packaging, and robotics environments.
Shipping & Payment Options
Warranty
Repair
We offer a repair service for the HCS01.1E-W0018-A-03-E-S3-EC-NN-L4-NN-FW.
Want to 
