R911341250 (HCS01.1E-W0018-A-03-B-ET-EC-EM-L3-NN-FW)
HCS IndraDrive Controllers
Technical Specifications
Weight
2.10kg
Dimensions
268 x 196 x 70 mm
Encoder Interface
1Vpp sin-cos, Hiperface, EnDat 2.1, EnDat 2.2
Firmware
Must be obtained separately
Position
Installation instructions must be followed
Operating Temperature
Specified Maximum
Safety Requirements
Country-specific regulations
Fault Mechanism
Motor control error
Shipping
Worldwide via logistics agents
Connectors
Cannot connect or disconnect under load
Protection
Water and foreign objects
Monitoring Functions
Present in components
Emergency Stop Mechanism
Mandatory for operation
Standstill Mode
Required before entering danger zone
Grounding Conductor
Connected to housing with M5 x 12 screw
Tightening Torque
5Nm.
Frequently Asked Questions
How does humidity affect this controller’s operational safety?
The unit functions reliably below 90% non-condensing relative humidity. Maintaining this range prevents corrosion and ensures stable insulation resistance during long-term industrial operation.
What are the ambient limits for HCS01.1E-W0018-A-03-B-ET-EC-EM-L3-NN-FW?
It is designed for continuous operation up to 40°C ambient temperature. Staying within this limit protects internal components and preserves consistent torque output efficiency.
How does altitude influence electrical insulation capability?
At elevations above 1000 meters, thinner air reduces cooling efficiency and dielectric strength. Derating may be necessary to maintain safe thermal and voltage margins.
Why is vibration control important in installation environments?
Vibration isolation prevents micro-fractures in solder joints and connector fatigue. Using shock-damped mounting structures enhances long-term mechanical reliability and reduces maintenance frequency.
How does cabinet design support environmental protection standards?
Enclosing the controller in a sealed cabinet ensures compliance with Pollution Degree 2 conditions. This configuration limits conductive dust exposure and safeguards internal electronics.
Common Misspellings
HCS011EW0018A03BETECEML3NNFW
HCS01 1E W0018 A 03 B ET EC EM L3 NN FW
hcs01.1e-w0018-a-02-e-s3-ec-ep-nn-nn-fw
HCS1.1E-W0018-A-03-B-ET-EC-EM-L3-NN-FW
Internal Product Review
The Bosch Rexroth HCS01.1E-W0018-A-03-B-ET-EC-EM-L3-NN-FW drive controller uses MultiEthernet communication and supports IndraDyn Hiperface or EnDat encoders. It operates on 3× AC 200–500 V with an 18 A peak current and STO safety interface. The device is suitable for robotics, packaging, and material handling automation systems.
Shipping & Payment Options
Warranty
Repair
We offer a repair service for the HCS01.1E-W0018-A-03-B-ET-EC-EM-L3-NN-FW.
Want to 
