MDD090A-N-020-N2L-130PL2
MDD Synchronous Motors
Technical Specifications
Balancing
Standard
Holding Brake
With blocking brake
Holding Brake Torque
11.0 Nm
Centering Diameter
130 mm
Housing
Standard
Motor Feedback
Digital servo feedback (DSF)
Continuous Torque at Standstill
3.7 Nm
Motor Length Code
A
Motor Size
090
Nominal Speed
2000 min⁻¹
Shaft Seal
With shaft seal
Shaft Type
keyway
Connection Direction
Left
Connection Type
Connector
Product Type
Motor for digital drive controllers
Shaft End
Standard (without side B shaft end)
Frequently Asked Questions
What are the cable limits and best practices for the feedback line on long runs?
Using Indramat DSF feedback cables, the maximum length is 75 m. Employ the specified 12-pin feedback connector and ready-made shielded cables to maintain signal integrity.
What thermal protections exist and how do they interact with the drive?
A PTC sensor in the windings is monitored by the controller; on over-temperature the drive trips with a fault. Expect derating at higher ambient temperature or installation altitude.
What mounting interfaces and orientations enable retrofit flexibility?
The size-090 supports IM B5 and IM B14 flange patterns for drop-in swaps. The motor can be installed in any orientation without performance penalty.
Which applications typically benefit from this motor’s dynamics?
Machine-tool indexing, pick-and-place robotics, and precise conveyor positioning commonly leverage its low inertia and synchronism. These use cases are standard pairings with MDD motors.
How should torque–speed curves be used during selection?
Use them to ensure duty points remain within thermal and speed limits. They also show where peak torque is usable across the speed range for cyclic moves.
Common Misspellings
MDD-090A-N-020-N2L-130PL2
MDD090A N 020 N2L 130PL2
MDD090A-N-020-N2L-130-PL2
MDD090AN020N2L130PL2
MDD90A-N-020-N2L-130PL2
MDDO90A-N-020-N2L-130PL2
MDDO9OA-N-O2O-N2L-13OPL2
Internal Product Review
The Bosch Rexroth Indramat MDD090A-N-020-N2L-130PL2 is a synchronous digital-servo motor built for high-precision motion control. It offers 3.7 Nm continuous standstill torque, a 11.0 Nm holding brake torque, runs at 2000 min⁻¹ nominal speed, includes a keyway shaft, connector interface, digital feedback and a shaft seal. Its housing is desgined to protect internal components against dust and mechanical stress.
Shipping & Payment Options
Warranty
Repair
We offer a repair service for the MDD090A-N-020-N2L-130PL2.
Want to 
