MDD090C-N-030-N2L-130PB1
MDD Synchronous Motors
Technical Specifications
Balancing
Standard
Holding Brake
With blocking brake
Holding Brake Torque
6.5 Nm
Centering Diameter
130 mm
Housing
Standard
Motor Feedback
Digital servo feedback (DSF)
Continuous Torque at Standstill
10.4 Nm
Motor Length Code
C
Motor Size
090
Nominal Speed
3000 min⁻¹
Shaft Seal
With shaft seal
Shaft Type
keyway
Connection Direction
Side B
Connection Type
Connector
Product Type
Motor for digital drive controllers
Shaft End
Standard (without side B shaft end)
Frequently Asked Questions
What trade-offs come from “standard balancing” for a rotor in high-speed applications?
Standard balancing is adequate for many duties, but for very high-speed or low-vibration systems, you may demand higher balance class (e.g. G2.5 or better) to reduce bearing loads and resonance.
In what cases is the centering diameter of 130 mm (flange interface) critical for integration?
The 130 mm centering diameter defines how the motor mates to machine frames or gearboxes; precise alignment and bearing preload depend on this interface to avoid misalignment loads.
What installation or alignment tolerances matter for the side-B connector orientation?
Since the connector is on side B, cable routing must avoid interference; also maintain angular and radial alignment to avoid stress on the connector pins during assembly.
How is commutation performance affected if rotor inertia or load inertia is much higher than expected?
A mismatch between motor and load inertia reduces servo bandwidth and can lead to oscillation or slower settling, so keep the total reflected inertia reasonably matched (e.g. ≤ 10× motor’s rotor inertia).
How would you refer to this motor in a technical support query using its exact model and manufacturer?
Use “Bosch Rexroth MDD090C-N-030-N2L-130PB1” when requesting firmware, support, or spares to ensure precise identification.
Common Misspellings
MDD-090C-N-030-N2L-130PB1
MDD090C N 030 N2L 130PB1
MDD090C-N-030-N2L-130-PB1
MDD090CN030N2L130PB1
MDD90C-N-030-N2L-130PB1
MDDO90C-N-030-N2L-130PB1
MDDO9OC-N-O3O-N2L-13OPB1
mdd090c-n-030-n2l-130pb1
Internal Product Review
The MDD090C-N-030-N2L-130PB1 motor from Bosch Rexroth includes a 6.5 Nm holding brake and a keyway shaft with a shaft seal. It offers 10.4 Nm continuous torque at a nominal speed of 3000 min⁻¹ and uses digital servo feedback. This motor is suitable for use in robotics, packaging, and textile machinery.
Shipping & Payment Options
Warranty
Repair
We offer a repair service for the MDD090C-N-030-N2L-130PB1.
Want to 
