MDD093B-N-020-N2L-110PL2
MDD Synchronous Motors
Technical Specifications
Balancing
Standard
Holding Brake
With blocking brake
Holding Brake Torque
22 Nm
Centering Diameter
110 mm
Housing
Standard
Motor Feedback
Digital servo feedback (DSF)
Continuous Torque at Standstill
14.5 Nm
Motor Length Code
B
Motor Size
093
Nominal Speed
2000 min⁻¹
Shaft Seal
With shaft seal
Shaft Type
keyway
Connection Direction
Left
Connection Type
Connector
Product Type
Motor for digital drive controllers
Shaft End
Standard (without side B shaft end)
Frequently Asked Questions
How is the holding brake managed during e-stop or power loss?
The drive can clamp immediately, below 10 rpm, or after ~400 ms—selectable via parameters. It is a holding brake, not a service brake; add external safety measures if personnel protection is required.
What should be done if the motor’s brake has been idle in storage for years?
Reseat it and run the motor ~100 rpm, close the brake for ~60 seconds, then reconnect it to the drive. This restores proper friction conditions before returning to service.
Does adding a shaft seal change the environmental rating at the shaft?
Yes without a shaft seal the shaft area is IP50; with a shaft seal it is IP65. Plan for splash/dust exposure accordingly and observe ambient limits.
How should a keyed shaft be coupled to the load?
Use a hub keyed per DIN 6885 with proper fit and axial clamping to prevent fretting and backlash. Align carefully to protect bearings and preserve servo stiffness.
What does a nominal speed around 2000 min⁻¹ imply for sizing and gearing?
Ensure the drive can supply continuous current at low speeds and check S1/S6 curves when choosing ratios. This speed suits geared axes or direct indexing where torque at low speed is prioritized.
Common Misspellings
MDD-093B-N-020-N2L-110PL2
MDD093B N 020 N2L 110PL2
MDD093B-N-020-N2L-110-PL2
MDD093BN020N2L110PL2
MDD93B-N-020-N2L-110PL2
MDDO93B-N-020-N2L-110PL2
MDDO93B-N-O2O-N2L-11OPL2
mdd093b-n-020-n2l-110pl2
Internal Product Review
The Bosch Rexroth Indramat MDD025C-N-100-N2K-040FE0 motor is designed for digital drive controllers, featuring a nominal speed of 2000 min⁻¹ and 14.5 Nm continuous torque at standstill. Its blocking brake with 22 Nm torque and digital servo feedback ensure precision. Widely applied in robotics, CNC machining and automated packaging lines.
Shipping & Payment Options
Warranty
Repair
We offer a repair service for the MDD093B-N-020-N2L-110PL2.
Want to 
