MDD093C-N-040-N2L-130PL2

The MDD093C-N-040-N2L-130PL2 belongs to the MDD Synchronous Motors series manufactured by Bosch Rexroth Indramat. It is a motor for digital drive controllers, intended to generate precise torque and speed in industrial automation axes. The unit combines a 093 frame size with a C-length housing, and its shaft end follows the standard single-ended design. A connector on the left side supplies power and feedback to the drive, letting OEMs wire the motor quickly inside machines that rely on closed-loop positioning.

The motor reaches a nominal speed of 4000 min⁻¹, allowing fast cycle times when paired with compatible drives. A centering diameter of 130 mm aligns the flange accurately on mounting fixtures, minimizing radial runout. The integrated blocking brake delivers 22 Nm of static holding torque so vertical or suspended loads remain stationary during power loss. Power and feedback conductors exit on the Left side, a layout that simplifies cable routing in cabinets where drives are installed to the motor’s left. Motion is transmitted through a keyway shaft, giving positive mechanical engagement with couplings or pulleys.

The encoder provides digital servo feedback (DSF), enabling the controller to correct position and velocity errors with high resolution. A protective shaft seal prevents lubricant from escaping and blocks contaminants from entering the housing. Rotor balancing is kept to a Standard grade, ensuring vibration levels acceptable for general-purpose machinery without additional balancing steps. The physical envelope follows motor length code C, which increases stack height over shorter variants and raises continuous torque potential. A standard housing finish, a connector style interface, and the absence of a second shaft end round out the specification set without altering the performance values discussed above.