MDD093D-N-030-N2M-130PL2

What happens to thermal performance when running continuously near 3000 min⁻¹ with 24 Nm?

The motor must dissipate heat through its housing, and if ambient or mounting conditions limit cooling, continuous torque may need derating to avoid thermal overload. Ensure good thermal coupling (e.g. flange cooling, airflow) to maintain torque at high RPMs.

How does the 22 Nm brake torque affect system safety and sizing?

The blocking brake can reliably hold the rotor against applied loads up to 22 Nm when unpowered; for vertical axes or high-holding loads, you must ensure mechanical design does not exceed this. Always include safety margins or external locking if system torque requirements exceed 22 Nm during fault conditions.

Why is using the integrated multiturn absolute encoder with DSF advantageous over separate encoders?

The absolute encoder retains full rotor position information even after power loss, eliminating the need for homing at startup. This lowers startup delay and reduces device complexity by not requiring a separate axis-level encoder.

How does the centering (130 mm) diameter impact mechanical integration?

The 130 mm centering diameter determines the flange and mounting interface to your machine frame, enforcing concentricity tolerances and stiffness. A mismatch here may lead to misalignment, vibrations, or mechanical stresses.

What alignment or calibration steps are needed if the encoder is replaced or serviced?

The encoder must be correctly aligned to the rotor, and commutation offsets must be programmed into the drive/controller. Misalignment can degrade performance or cause positioning errors — use the manufacturer’s commissioning software for precise encoder setup.

MDD-093D-N-030-N2M-130PL2

MDD093D N 030 N2M 130PL2

MDD093D-N-030-N2M-130-PL2

MDD093DN030N2M130PL2

MDD93D-N-030-N2M-130PL2

MDDO93D-N-030-N2M-130PL2

MDDO93D-N-O3O-N2M-13OPL2

The MDD093D-N-030-N2M-130PL2 servo motor by Bosch Rexroth delivers 24.0 Nm continuous torque and operates at a nominal speed of 3000 min⁻¹. It features a 22 Nm blocking brake, digital servo feedback, and a multiturn absolute encoder. This motor is well-suited for use in packaging, robotics, and CNC machinery applications.