MDD093D-N-040-N2L-110PA1

The MDD093D-N-040-N2L-110PA1 servo motor is built by Bosch Rexroth Indramat and belongs to the MDD Synchronous Motors series. Designed for integration with digital drive controllers, it converts electrical energy into precise rotary motion for positioning and velocity tasks in automated machinery. Its D-length frame increases the magnetic stack to raise torque capability, while the size-093 housing keeps the motor compatible with standard mounting layouts on packaging lines, pick-and-place gantries, and other assemblies that rely on rapid start-stop cycles.

At standstill the motor can deliver a continuous torque of 24.0 Nm, so closed-loop axes can maintain load without overheating. During motion, a nominal speed of 4000 min⁻¹ defines the synchronous operating point that matches high-frequency controller commands. For emergency holding or vertical loads, the integrated blocking brake supplies 11 Nm of static torque. Position information is returned through digital servo feedback, allowing high-resolution commutation and fault monitoring. A centering diameter of 110 mm aligns the flange precisely with gearboxes or direct-drive couplings. Standard housing construction dissipates heat through the ribbed surface, and balancing is standard to limit bearing stress at top speed.

All electrical and encoder leads exit on Side A, and the motor-side plug-in connector simplifies cable replacement during service. The keyed shaft follows DIN 6885 and is supplied as a keyway end without a secondary shaft on side B, while a built-in shaft seal guards the internal bearings from coolant spray. The standard housing profile supports direct flange mounting near gear reducers or belt pulleys where compact axial length is important.