MDD093D-N-040-N2M-130PL0

How does delivering 24 Nm continuous torque at standstill affect system inertia matching?

That high holding torque means the motor can resist external loads even when stopped, which helps in tight coupling to loads with inertia. It relaxes the need for heavy gearboxes or large safety margins in acceleration design.

What considerations arise from the motor using a keyway shaft?

A keyway shaft provides positive torque transmission without slippage, but requires careful machining tolerances and stress relief to avoid fatigue at key corners. It also demands proper key material selection to avoid relative motion and fretting.

Why might the absence of a blocking (holding) brake be important in application design?

Without a built-in brake, the system must rely on external braking or mechanical locks to hold position under load during power-off or emergency stops. In high-safety or vertical axis installations, an external brake or fail-safe lock is essential.

Can you use this motor in servo loops that require high bandwidth and minimal lag?

Yes — with digital servo feedback (DSF) and the integrated encoder, control loops can run at high bandwidth and low latency, supporting rapid dynamic response. However, the drive electronics and cabling length will also influence achievable loop frequency.

How does shaft sealing affect reliability in industrial environments?

The inclusion of a shaft seal helps protect internals from dust, oil, and environmental contaminants, increasing longevity and reducing maintenance. But you must also consider seal friction and ensure compatibility with lubricants.

MDD-093D-N-040-N2M-130PL0

MDD093D N 040 N2M 130PL0

MDD093D-N-040-N2M-130-PL0

MDD093D-N-040-N2M-130-PLO

MDD093D-N-040-N2M-130PLO

MDD093DN040N2M130PL0

MDD93D-N-040-N2M-130PL0

MDDO93D-N-040-N2M-130PL0

MDDO93D-N-O4O-N2M-13OPLO

The MDD093D-N-040-N2M-130PL0 motor by Bosch Rexroth features a 130 mm centering diameter, digital servo feedback, and a multiturn absolute encoder. It delivers 24.0 Nm torque at standstill with a nominal speed of 4000 min⁻¹ and includes a shaft seal and keyway shaft. This motor is suitable for use in robotics, CNC machines, and packaging automation.