R911290522 (MDD115D-N-015-N2L-130PR0)

How does the keyed and sealed shaft of MDD115D-N-015-N2L-130PR0 assist in torque transmission and environmental protection?

The keyway provides positive mechanical indexing, preventing slippage under cyclic torque and easing phase alignment for camming applications. Its shaft seal limits ingress of aerosols and coolant splash toward the front bearing and encoder cavity.

What commissioning considerations arise from the right-hand, connector-type power/feedback orientation on MDD115D-N-015-N2L-130PR0?

The right-side connectors determine cable exit, bend radii and drag-chain routing; respecting these avoids added strain at high traverse rates. Its standardized Indramat pinouts simplify power, PTC, brake and feedback wiring to digital drives.

Why is a 130 mm centering diameter advantageous for MDD115D-N-015-N2L-130PR0 in precision assemblies?

It registers the motor concentrically to the machine flange for minimizing radial runout and coupling misalignment. It stabilizes bearing loads and lowers vibration transmission into ball-screw, belt or gearbox interfaces.

How does 57 Nm continuous torque at standstill benefit indexing duties on MDD115D-N-015-N2L-130PR0?

Its continuous stall torque enables long dwell times during clamp-and-process operations without overheating for maintaining commanded holding torque. Its consistency supports accurate start/stop indexing on dial tables, feeders and print cylinder registration.

What operating envelope should I expect for MDD115D-N-015-N2L-130PR0 regarding speed, protection, and environment?

The model’s nominal speed is 1500 rpm, while typical variants are built to IP65 for suiting wash-down splash and dust exposure when cabled correctly. It is important to observe ambient and storage limits and maintain ventilation clearances specified by the supplier.

MDD115DN015N2L130PR0

MDD115D N 015 N2L 130PR0

mdd115d-n-015-n2l-130pr0

The Indramat’s MDD115D-N-015-N2L-130PR0 synchronous motor is built to deliver 57 Nm torque at standstill. It includes a DSF encoder feedback and a keyed, sealed shaft centered at 130 mm. This motor offers right-sided connector for streamlining digital drive hookup. It is applicable in textiles, tool changers and punching/nibbling systems due to its nominal speed of 1500 rpm and standard balancing category.