MS2N10-E0BNA-CSAK3-NNNNN-NN

The MS2N10-E0BNA-CSAK3-NNNNN-NN belongs to the MS2N Synchronous Servo Motors series produced by Bosch Rexroth Indramat. As a synchronous servo motor, it provides closed-loop torque and position control for automation axes where dynamic response and repeatable accuracy are critical. The motor follows the B5 / IM3001 mounting code, allowing it to be flange-mounted directly to a compatible machine surface. A PT1000 temperature sensor allows the connected drive to monitor winding temperature in real time and respond to excessive heat. Its MS2N10 size balances installation footprint and torque output for use in medium-frame machinery.

The motor uses an advanced 20-bit ACURO®Link encoder that provides high-resolution feedback. Its single-turn absolute format gives the controller the rotor position within one mechanical revolution after power-up. The motor reaches a maximum speed of 3000 rpm, supporting fast indexing and direct coupling to loads with suitable speed requirements. A forced-ventilation axial blower rated for 230 V at 50 Hz moves cooling air through the housing, helping the motor maintain its rated output during sustained operation. A low-inertia rotor reduces the torque required for rapid acceleration, deceleration, and direction changes. Power and feedback conductors use a double cable connection with a fixed M58 connector and a rotatable M17 connector. The fixed connector carries motor power, while the rotatable connector provides flexible routing for feedback wiring in confined installations.

A Size 3 electrically released holding brake secures the shaft when electrical power to the brake coil is removed. This arrangement helps prevent an attached load from moving while the motor is not producing torque. Output torque is transmitted through a keyed shaft with a shaft sealing ring, providing positive engagement with a coupling while limiting lubricant migration and contaminant entry. The stator uses frame length E, which provides the magnetic stack length required for this motor configuration. A set of standard bearings supports the applicable radial and axial shaft loads during operation. The housing has a standard RAL 9005 black varnish coating that helps protect its external surfaces from oil mist and routine industrial exposure. Standard flange concentricity supports accurate alignment between the motor shaft and the connected machine component.