MSK101D-0300-FN-S1-BG0-NNNN
MSK IndraDyn S Synchronous Motors
Technical Specifications
Cooling
Liquid cooling
Power Connector
B-Side
Encoder Interface
Hiperface
Encoder Resolution
128 signal periods
Encoder Technology
Optical
Encoder Turn Type
Singleturn
Motor Length
D
Motor Size
101
Holding Brake
Without holding brake
Design
Standard
Product Type
IndraDyn S Synchronous Servomotor
Shaft Type
Plain shaft
Winding Code
0300
Continuous Current at Standstill 100 K
34.9 A
Continuous Torque at Standstill 100 K
57.0 Nm
Maximum Current
137.7 A
Maximum Torque
160.0 Nm
Winding Inductivity
3,200 mH
Frequently Asked Questions
How does the optical Hiperface singleturn encoder affect control latency or jitter?
The 128 signal periods optical Hiperface encoder offers high resolution feedback with minimal latency, but care must be taken in cable routing and shielded wiring to avoid signal jitter or cross-talk.
How susceptible is the motor to overheating faults and what recovery behavior is expected?
Liquid-cooled MSK motors may take over two hours to cool sufficiently after a thermal shutdown, so fault recovery should allow full cooldown before reapplying power.
What are the storage or transport precautions for this liquid-cooled motor?
Prior to transport or cold storage (below 0 °C), fully drain the coolant lines to avoid frost damage to the cooling passages.
How does winding inductance (3,200 mH) influence drive tuning or responsiveness?
The relatively high inductance smooths current ripple but also slows current rise time, so drive control loops must be tuned to balance responsiveness versus stability under dynamic loads.
Can the motor operate reliably under radial or axial shaft loads?
Yes, provided the radial and axial forces stay within the allowable limits specified in the “Bearing & Shaft Load” section of the project planning manual; exceeding them shortens bearing life.
Common Misspellings
MSK101D0300FNS1BG0NNNN
MSK101D 0300 FN S1 BG0 NNNN
MSK-101D-0300-FN-S1-BG0-NNNN
Internal Product Review
The MSK101D-0300-FN-S1-BG0-NNNN servomotor by Bosch Rexroth features liquid cooling, 57.0 Nm continuous torque, and a 128-period optical singleturn encoder with Hiperface interface. It delivers up to 160.0 Nm maximum torque and operates with a continuous current of 34.9 A. This motor is commonly used in robotics, packaging lines, and metal forming machinery.
Shipping & Payment Options
Warranty
Repair
We offer a repair service for the MSK101D-0300-FN-S1-BG0-NNNN.
Want to 
