VT-HMC-2-1X/M-P-00/00
VT-HMC Digital Axis Controllers
Rated 4.6 stars (26 total reviews)
The VT-HMC-2-1X/M-P-00/00 is a compact digital axis controller produced by Bosch Rexroth Indramat and placed within the VT-HMC Digital Axis Controllers series. Designed for cabinet installation, the unit coordinates motion commands for hydraulic or electro-mechanical actuators in small-scale machines. By combining closed-loop calculation and field parameterization, it allows OEMs to synchronize multiple drives without installing a full PLC. The controller stores application data locally, letting maintenance personnel swap hardware quickly while keeping axis behavior consistent. Its firmware focuses on positioning, velocity, and pressure loops typically required in presses and test stands.
Electrical power for logic and I/O is supplied at 24 VDC, letting the device share the same control circuit that feeds most industrial sensors. Internally it computes position for 2 independent axes, so a single unit can handle synchronized clamp and feed motions. Backup and firmware updates are written to a SD Memory Card, eliminating the need for a programming PC during replacement. With a mass of only 0.64 kg, the controller imposes negligible load on light control panels, and its low thermal mass simplifies passive cooling strategies in sealed enclosures.
Up to 4 GB of removable storage ensures that large parameter sets, trend logs, and multiple firmware images remain available on the card. Commissioning is completed over Ethernet, so engineers can reach the axis loops through standard network tools rather than proprietary cables. The card slot communicates via a dedicated SPI bus, separating storage traffic from the realtime kernel. Mechanical installation uses a snap-fit DIN rail bracket that accepts common 35 mm profiles, enabling the controller to sit beside distributed I/O modules from Bosch Rexroth Indramat and third-party vendors without additional brackets.
Technical Specifications
Maximum input frequency
250 kHz
Ambient Operating Temperature
-20 °C to +60 °C
Analog Input Resolution
14 bit
Analog Input Voltage Range
-10 V to +10 V
Analog Inputs Quantity
8
Analog Out Max Load (current)
500 Ω
Analog Out Min Load Impedance
1000 Ω
Analog Output Resolution
16 bit
Analog Outputs Quantity
4
Backup/restore Medium
SD Memory Card
Controlled Axes
2
Device Weight
0.64 kg
Digital Inputs Quantity
8
Digital Output Current Capacity
50 mA
Digital Outputs Quantity
4
External Fuse
3.15 A (Time-Lag)
Linear Potentiometer Outputs
RS485 Encoder Interfaces
Max Operating Height
2000 m
Max Residual Ripple (40-400 Hz)
5 Vpp
Max Sd Card Capacity
4 GB
Max. Sensor current Supply
100mA
Maximum admissible temperature change
5 °C/min
Maximum Current Load
2.2 A (for two axes)
Mounting Method
DIN Rail
Nominal Operating Voltage
24 VDC
Operating Voltage
24 VDC nominal (17.5-30 V allowable)
Parameterization Interface
Ethernet
Position Ctrl Scan Time (min)
0.5 ms
Protection Class
IP20
Relative air humidity
10 to 95% (without condensation)
Sd Card Interface
SPI
Sensor Voltage Supply Range
UB - 4 V to UB - 2.5 V
Signal Delay time (digital Outputs)
0.5 to 1.2 ms
Supply Voltage
24 VDC
Weight
0.6 kg
Fax: 1-919-867-6204
Shipping & Payment Options
Warranty
Indramat USA 1 Year Warranty
Repair
We offer a repair service for the VT-HMC-2-1X/M-P-00/00. Exchange
Want to sell your VT-HMC-2-1X/M-P-00/00?
