R911283448 (MKD112C-058-GG0-AN)

Why is the G–plain shaft with shaft seal on MKD112C-058-GG0-AN advantageous for contaminated or spray-down environments?

The sealed plain shaft limits ingress at the drive end and supports compliant, backlash-managed couplings. It allows use under water-jet cleaning and dusty conditions when installed with proper gaskets and connectors.

How should the 60 Nm rated torque and 38 Nm continuous standstill torque of MKD112C-058-GG0-AN be applied in duty-cycle calculations?

The 60 Nm for continuous-at-speed operation at the rated point, while thermal limits govern peak envelopes. Its 38 Nm standstill value defines sustained holding or indexing capability without motion for informing dwell segments in cyclic profiles.

Which Rexroth drives are sanctioned for MKD112C-058-GG0-AN, and what interface considerations follow?

The Rexroth specifies DIAX04, ECODRIVE, DURADRIVE and INDRADRIVE controllers for MKD motors, with SERCOS/analog interfaces per drive generation. Its controller-specific parameterization and cabling rules.

How do the 130 mm centering diameter and 192 mm flange of MKD112C-058-GG0-AN assist in alignment, stiffness, and interchangeability?

These standardized faces locate the motor concentrically to improve coupling alignment and bolted joint rigidity while easing replacement across 112-frame variants. Its dimensional commonality simplifies machine retrofits and reduces new-fixture engineering effort.

What resolver cabling and grounding practices should be followed to minimize noise susceptibility when integrating MKD112C-058-GG0-AN?

The Rexroth-specified hybrid cables maintain continuous shields and bond grounds both via the motor cable and a separate protective conductor as prescribed. Its connector mate/de-mate under power that follows controller firmware commissioning procedures.

MKD 112C-058-GG0-AN

MKD-112C-058-GG0-AN

MKD112C-O58-GGO-AN

MKD112C058GG0AN

MKD112C 058 GG0 AN

mkd112c-058-gg0-an

The MKD112C-058-GG0-AN motor from Bosch consumes 9.3 kW of rated power and operats at a nominal a speed of 3000 rpm. It features 60 Nm of rated torque and possess RSF resolver feedback. This unit comes with a sealed plain shaft, IP65 enclosure and 192 mm flange to suit machine tools, packaging lines and printing machinery. It has no holding brake and its output-connector terminations streamline cabinet integration.